Arduino Pro Micro Eagle Library -

This defines where the holes and board outline go.

Place the Pads (Left Side):

Place the Pads (Right Side):

Add Names:

Click Save.

If you prefer to build your own library (good for learning or custom pin mapping), follow these steps: arduino pro micro eagle library

Manually creating a Pro Micro library is tedious and error-prone. Instead, use a community-tested library: This defines where the holes and board outline go

RAW, GND, RST, VCC, TX, RX, GND, SCL, SDA, A3, A2, A1, A0
(on left)
D15, D14, D16, D10, D9, D8, D7, D6, D5, D4, LED, D12, GND, RST
(on right)

This defines where the holes and board outline go.

Place the Pads (Left Side):

Place the Pads (Right Side):

Add Names:

Click Save.

If you prefer to build your own library (good for learning or custom pin mapping), follow these steps:

Manually creating a Pro Micro library is tedious and error-prone. Instead, use a community-tested library:

RAW, GND, RST, VCC, TX, RX, GND, SCL, SDA, A3, A2, A1, A0
(on left)
D15, D14, D16, D10, D9, D8, D7, D6, D5, D4, LED, D12, GND, RST
(on right)

カテゴリーキャプション