Cobra 3195 Alarm Manual Full -

The Cobra 3195 is NOT a remote start unit. It is a security and central locking system only. Do not attempt remote start wiring.

| Mode | Description | When to Use | |------|-------------|------------| | OFF | All sensors disabled; system idle. | Home, while you’re present. | | HOME | Perimeter sensors (doors/windows) active; interior motion sensors disabled. | You’re inside but want protection against burglary. | | AWAY | Both perimeter and interior motion sensors active. | You’re out of the house. | | Panic (triggered by holding SILENCE for 3 s) | Instant alarm, sends immediate alert. | Emergency (break‑in, medical). |

Fix: Lower the shock sensor sensitivity (see 3.3). Also check the door pin switches – if any are corroded, the 3195 sees a door open. Clean or replace pin switches. cobra 3195 alarm manual full

The cobra 3195 alarm manual full is still in demand because many classic cars (1990s Ford, Vauxhall, Rover, and Japanese imports) have this system factory-fitted or dealer-installed. However, if your 3195 is experiencing frequent false alarms, no replacement remotes, or corroded modules, consider upgrading to:

Until then, keep this guide saved – because the original cobra 3195 alarm manual full is no longer in print, and having a digital reference will save you hours of frustration. The Cobra 3195 is NOT a remote start unit

Search for "Cobra 3195 alarm manual PDF" or "Cobra 3195 installation manual" to download the exact wiring diagram, full programming codes, and safety details for your unit.

Note: The Cobra 3195 series is a popular range of vehicle security systems (often sold under brands like Viper, Clifford, or directly as Cobra Atena). Because specific manuals can vary slightly based on the installation configuration in your specific vehicle, this guide covers the standard operations, programming menus, and troubleshooting for the Cobra 3195 system. Unlock/Disarm: Press the Unlock Button (usually the smaller

The system can be programmed to automatically lock the doors when you drive off (ignition on + speed sensor) or after a certain time. This requires dealer/installer programming via the diagnostic port.

A: Enter programming mode (ign ON, valet 5 sec). Then press valet button 6 times. Siren chirps 2 times to confirm passive OFF. 1 chirp = passive ON.