The manual’s troubleshooting section maps codes (e.g., E01 — Overload, E03 — Battery Short) to likely causes and corrective steps, often with a decision tree.
Example: E01 Overload → Verify load does not exceed rated capacity; if persistent, inspect connected equipment for short circuits; if load is within limits, check for stuck relays or faulty transistors and contact service.
Common CVF-S1 fault codes:
This is the most searched procedure inside the manual. To wire a three-wire momentary switch setup:
How it works: Press the Start button to run; press the Stop button (or open the NC contact) to halt. The manual warns that X1 must be closed for the motor to run (safety logic).
