Eberle Instat 6 User Manual English -
Before your thermostat knows when to turn on the heat, you must tell it what time it is. Here is how to set the clock:
While this article aims to be a complete replacement for the eberle instat 6 user manual english, we strongly recommend keeping an official PDF on your computer or phone. You can obtain it from:
If the manual is no longer available, contact your heating installer – they often have archived copies. eberle instat 6 user manual english
You can select modes using the slide switch or buttons.
| Mode | Symbol | Function | | :--- | :---: | :--- | | Off | ⏻ or 0 | The thermostat is switched off (frost protection remains active, usually maintaining ~5°C to prevent pipe freezing). | | Manual / Comfort | ☀ or Hand | The thermostat maintains the temperature you set on the dial continuously. | | Automatic / Program | 📅 or Clock | The thermostat follows the built-in weekly time program. | | Standby / Eco | 🌙 | The thermostat maintains a lower "setback" temperature (usually 3-4°C lower than comfort) to save energy. | Before your thermostat knows when to turn on
The Eberle Instat 6 typically carries a 2-year manufacturer’s warranty from the purchase date. The warranty is void if:
For technical support, contact your local Eberle distributor. Provide the full model number (e.g., Instat 6-230, Instat 6-24V) from the rear label. While this article aims to be a complete
Because the original manual may be translated poorly, here is a plain-English troubleshooting table:
| Display Symbol / Error | Meaning (from Manual) | Solution |
| :--- | :--- | :--- |
| ERR | Floor sensor short circuit or broken | Call an electrician. The unit defaults to air sensing only. |
| Battery symbol flashing | Internal backup capacitor failing | The memory will lose time when power is off. Replace the unit (Instat 6 has non-replaceable battery). |
| Sun & Snowflake together | Manual override active until next program change | Press Mode button to return to Auto. |
| Floor symbol flashing | Floor temperature exceeded limit | Heating stops. Check floor sensor settings (Installer menu, Param 2). |
| Stuck at 5°C | Frost protection mode active | Check if Power button is turned off. Press I/O once. |