Ms-7613 Ver 1.1 Motherboard Manual

If you are trying to put this board into a non-HP case, this is the manual info you actually need: The front panel pins (Power LED, Power Switch, Reset Switch) are non-standard. On a standard motherboard, these are individual pins. On the MS-7613, HP often grouped them into a single block connector.

If you buy this board used, you will immediately notice something frustrating: The BIOS is neutered. ms-7613 ver 1.1 motherboard manual

The manual’s Qualified Vendor List (QVL) is outdated, but based on its electrical specs, here is modern (used market) compatibility: If you are trying to put this board

| Component | Best match (proven working) | | --- | --- | | CPU | Core 2 Quad Q9650 (1333 MHz FSB) – check cooling. | | RAM | 2 x 4 GB DDR3-1066 (Kingston KVR1066D3N7/4G) – 8 GB max. | | GPU | Any PCIe 2.0 or 1.0 card (e.g., Radeon HD 5450, GT 710) – no UEFI BIOS needed. | | SSD | SATA II SSD (Kingston A400) – works, but limited to 3 Gb/s. | | PSU | 250W–350W ATX (20+4 pin) – do NOT use modern high-wattage PSU without testing; the board has no +12V overcurrent protection. | If you buy this board used, you will

The manual explicitly says: “Do not install Pentium Extreme Edition 965 (130W TDP).” The VRM cannot handle it.