Sc7715 Imei Tool Now

While the SC7715-specific tool is excellent for its target chipset, you may encounter other Spreadtrum CPUs (SC7731, SC9832, etc.). In that case, consider:

For SC7715 specifically, the dedicated tool remains the fastest, most reliable method.

Right-click SC7715_IMEI_Write.exe → Run as administrator. The interface is minimalist: two IMEI fields (SIM1 and SIM2), a "Write" button, and a "Read" button.

Using the SC7715 IMEI Tool incorrectly can lead to a hard brick. Follow these preparation steps carefully.

The SC7715 IMEI Tool is a Windows-based utility that communicates directly with the SC7715 chipset via the phone’s diagnostic (Diag) port. It allows users to read, write, and repair IMEI numbers without needing to reflash the entire firmware. Sc7715 Imei Tool

Sometimes, a simple factory reset via recovery mode can corrupt the NVRAM index. The phone boots, but you cannot make calls. The tool fixes this by re-indexing and writing the correct IMEI string.

Once preparations are complete, follow these steps precisely.

If you lose IMEI again in the future:

Note: This guide is for educational and restoration purposes only. Tampering with IMEI numbers is illegal in many jurisdictions if done to clone a device or defraud a carrier. Always restore the original IMEI of the device. While the SC7715-specific tool is excellent for its

Requirements:

Step 1: Driver Installation Ensure the Spreadtrum USB Drivers are correctly installed on the PC. Without these, the computer will not recognize the phone when it is put into Download Mode.

Step 2: Launch the Tool Open the IMEI Tool (e.g., WriteIMEI.exe). You may need to run it as Administrator.

Step 3: Configure Settings

Step 4: Connection

Step 5: Flashing The tool should detect the COM port (e.g., SPRD U2S Diag Port). The progress bar will begin. Once the IMEI is written, the tool will display a "Pass" or "Success" message.

Step 6: Verification Disconnect the phone, reboot it, and dial *#06# on the dialer. The IMEI numbers should now be restored.