Assam Yellow Page
North East India's Local Information Service
x

Weltouch Cy-210b Manual -

Weltouch Cy-210b Manual -

What You’ll Need:

Steps:

  • Power-Up: Ensure the microcontroller and touch panel are powered last to prevent voltage spikes.
  • Initial Communication: Use a terminal tool or code (e.g., Arduino IDE) to send a basic read command (see datasheet for I2C addresses).

    • Best Practices:

    Hidden beneath the basic interface is an installer menu (sometimes called the "System Setup" menu). Only change these if you know your system type. Incorrect settings can damage your HVAC equipment.

    Without a physical manual, error codes are terrifying. Here is every code the CY-210B can produce: weltouch cy-210b manual

    | Error Code | Meaning | Solution | | :--- | :--- | :--- | | EEEEE | Overload (> capacity + 10%) | Remove weight immediately. Recalibrate if damaged. | | Lo | Low battery | Replace both AAA batteries. | | OUTZ | Out of zero range (pan moved during startup) | Remove everything from pan. Restart scale. | | Err-C | Calibration error | Wrong weight used or movement during cal. | | Stab | “Stable” indicator – not an error | This is normal. Wait for it to appear before reading. | | --OL-- | Load cell stuck or damaged | Check pan for debris. If clear, load cell is dead. |

    Common complaint: “My CY-210B fluctuates by 0.02g randomly.” What You’ll Need:

    Fix from manual: This is normal electrical noise. The manual specifies ±0.02g drift. Place the scale away from cell phones, Wi-Fi routers, and fluorescent lights.

  • No or unstable readings:
  • Error codes / flashing segments:
  • Inconsistent pulse waveform:
  • Device shuts off immediately:

    • If you have an incompatible system and need a replacement: Consider the Weltouch CY-230B (for heat pumps) or a Honeywell T6 Pro. Steps:

    Before diving into programming, let’s identify the key components of the CY-210B. Understanding the interface will make the manual instructions much easier to follow.

    💡 Pro Tip: To run the same temperature all day (e.g., no setback), set P1 and P2 to the same time and temperature.

    Related Content

    ↑