WoodWOP 5.0 is a widely used CNC programming environment for woodworking machines. This tutorial gives a concise hands‑on introduction to create a simple part, generate a toolpath, simulate it, and postprocess for a machine. Assumes WoodWOP 5.0 installed and basic familiarity with CNC concepts.
Prevent crashes. If the board is too thin, stop the program.
%P X=600 Y=400 Z=18 IF Z < 10 THEN GOTO "ERROR" ; ... rest of machining here ... M30
"ERROR:" M25 "Board too thin!"
M25 is a standard stop command that shows a message on the CNC control panel. woodwop 5.0 tutorial
By the end of the tutorial, a learner should be able to:
Move to the drilling location. Never drill without moving first. WoodWOP 5
G0 X50 Y100 Z10 ; Rapid move to safe height above the hole
We need to tell the spindle which tool to grab. Let's assume Tool #5 is a 5mm drill bit.
%TOOL=5 ; Select drill bit
%T5 ; Activate tool parameters
In WoodWOP 5.0, the semicolon (;) is your friend. It allows you to write comments so you remember what you did next week. M25 is a standard stop command that shows
%TOOL=10 ; 8mm Compression spiral
G0 G41 X10 Y10 Z5 ; G41 activates Left compensation (Cutter Comp)
CYCLE 23 ( "OUTLINE", Z= -18.1, F=3000, FZ=1500, ALLOWANCE=0)
If you work in the woodworking industry, specifically with HOMAG Group CNC machining centers (such as Weeke, BMG, or KAL), you have likely heard of WoodWOP. As of its 5.0 iteration, this software has become the gold standard for programming nesting, drilling, and routing operations.
However, for a new programmer, WoodWOP can look like a wall of green text from a 1980s mainframe. This tutorial will demystify WoodWOP 5.0, moving you from manual code editing to parametric programming mastery.