You can set multiple programs (e.g., lights on at 6:00 PM and off at 11:00 PM).

Quick diagnostic steps:

Press MODE to cycle through:

To change sensor type, control mode, or output logic:

| Parameter | Meaning | Typical Setting | | :--- | :--- | :--- | | SN | Sensor input type | K (for K-thermocouple), PT (for Pt100) | | UNIT | Temperature unit | C or F | | P | Proportional band | 30 (start here, then fine-tune) | | I | Integral time | 240 seconds | | D | Derivative time | 60 seconds | | OUT | Output mode | HEAT or COOL (for refrigeration) | | AL1 / AL2 | Alarm values | Set upper/lower limits |